![teraterm logging teraterm logging](https://img.informer.com/screenshots/688/688035_1.jpg)
- #Teraterm logging serial number#
- #Teraterm logging install#
- #Teraterm logging software#
- #Teraterm logging password#
To identify the possible problems, understand the overall configuration and have a good understanding of your end to end setup.Ģ. Step 3 Systematically eliminate each potential problem (from most likely to least likely) Step 2 Identify all potential problems that could be causing the symptoms. Step 1 Gather information that defines the specific symptoms. The following are the basic steps for troubleshooting: Generic Log collecting steps using below Terminal Emulators Troubleshooting and log collecting on a Switch CrashĤ. This guide provides basic troubleshooting and log collecting guidelines in a switch crash scenarioĢ. If you have any questions or trouble contact Red Lion Technical Support by clicking here or calling 1-87.This document introduces the basic concepts, methodology, and general troubleshooting guidelines for problems that may occur when configuring and using the IBM System networking switch. Red Lion standard product warranty applies. The use of this document is at your own risk. Red Lion is not responsible for any damage to equipment or connected systems. Red Lion makes no representation about specific knowledge of the customer's system or the specific performance of the system. It is the customer's responsibility to review the advice provided herein and its applicability to the system. Now reboot the device to finish the installation.
![teraterm logging teraterm logging](https://s3.manualzz.com/store/data/025553947_1-92ce47011036ed099be2313640e25154.png)
![teraterm logging teraterm logging](https://vasutioc.com/wp-content/uploads/2021/06/new-21.png)
The Sixnet/JBM device is now waiting for a file to be sent. At the command prompt type cd /tmp/ then hit the “ENTER” key.Refer above to step 4 of section “Logging into the Device” to log back into the device.Now close TeraTerm then reopen and refer above to step 3 in section labelled “Logging into device” and use the D series connection settings.For D series skip to Section “Uploading Package”) (NOTE: This process is only for C series devices.
#Teraterm logging password#
NOTE: You will notice that as you type the password nothing is displayed, this is a security feature.
#Teraterm logging serial number#
![teraterm logging teraterm logging](https://www.j-oosk.com/wp-content/uploads/log203.jpg)
You should be brought to a screen like this. Then click “OK” then hit the “ENTER” key. And make sure the settings are as follows. (For the 9 to 9 pin connection is generally COM1, for USB to Serial choose the COM connection associated with your USB to Serial Adaptor) Then click “OK”
#Teraterm logging install#
This will install TeraTerm with the default settings.